The MOTOR COVER is a quality product designed to protect the e-bike motor during transport. When transporting an e-bike on the roof of a car or attached to the rear of a vehicle, the bike is exposed to splash water, which can often penetrate through the housing into the engine. With the cover, the motor is protected against direct water impact.
The motor cover can be adjusted to the geometry of the frame and motor by tensioning the Velcro strips and using different types of Velcro.
When properly mounted, it will fit tightly to the motor and frame without causing any scratching that may result from a loose cover blowing in the wind.
The Motor Cover is intended for use only for transport protection and must be removed before riding the bike.
It will not prevent the motor from getting wet, but prevents the direct impact of splash water on the motor housing. The holes in the bottom of the cover are for draining water from above.
Suitable for e-bikes with mid-mounted motors such as BOSCH, YAMAHA, SHIMANO, IMPULSE, BROSE, PANASONIC and TranzX
Designed in Berlin and manufactured in the EU
Trekking, Bike Travel, Pendler, Livsstil/Bycykel, Hverdag, Pendling, Lifestyle / Single Speed, Urban Sports, Hybrid
Designet til elcykler
Materiale: Laminated neoprene, 4.5 mm thick
Leveringsomfang: Drivetrain protection and fasteners
Giv din mening til kende. Vær den første til at anmelde dette produkt.